PowerFlex 750 Series
      Back to home
      1. Knowledge Base
      2. Drives, Motors, & MCC
      3. PowerFlex 750 Series

      How do you wire a PowerFlex 753 for 2-Wire Control?

      This article describes how to connect a 2-wire control system to a PowerFlex 753 and the associated parameters

      2-Wire Control Non-Reversing  (Internal 24VDC Supply)

      How do you wire a PowerFlex 753 for 2-Wire Control?

      Parameters:

      Port 0: P308 (Direction Mode) to 2 "Rev Disable"

      Port 0: P163 (DI Run) to Port 0: P220 (Digital In Sts), bit 1 = Digital In 1

      NOTE:  Port 0: P150 (Digital In Cfg) will need to be set to 1 "Run Level" if using the same signal for STOP/RUN

      View Results:

      Port 0: P220 (Digital In Sts)   You can verify if input is going ON/OFF

      Port 0: P935 (Drive Status 1)  You can verify the status of the drive such as STOP ASSERTED, RUN, etc..