Skip to content
  • There are no suggestions because the search field is empty.

How do I set the IP Address on a 20-750-ENETR / 20-750-ENET2P PowerFlex Card?

This article provides information on how to setup the IP Address on a PowerFlex 20-750-ENETR / 20-750-ENET2P Communication Card via different methods

Method 1: The IP Address can be set via CCW (Connected Components Workbench) when you are connected to the main board of the VFD.

Method 2: The IP Address can be set using the bottom three dial switches on the front of the board. The switches only set the last octet of the address. 

NOTE: The first three octets are already pre-defined by the manufacturer.

192.168.1.XXX

20-750-ENETR / 20-750-ENET2P Manual

Method 3: You can use BOOTP Software or the Ethernet IP Address Commissioning Tool to setup the IP Address 

NOTE: Reference the table above to setup the dial switches to work with DHCP or BOOTP

NOTE: With any of the methods, the drive will need to be "powered cycled" before the IP Address will lock into the VFD.

How to setup the Ethernet IP Address Commissioning Tool Link